[. . . ] - If using more than one appliance at a time, it is important to ensure that the ring main is adequate to cope with the power requirements. - This appliance complies with EEC directive 89/336 regarding electromagnetic compatibility. To turn the appliance on, the switch at the back must be in the I position. The appliance emits a beep. The "ON" light also comes on and remains lit while power to the appliance is on. Press the Mode button (B) to switch to HIGH mode (maximum heat output). The display shows room temperature. [. . . ] During the season when the appliance is in use, clean the air intake and outlet grilles regularly using a vacuum cleaner. Cleaning and maintenance The heater should not required any maintenance. However before attempting to clean the heater, remove the plug from the power socket and allow the heater to cool. After the heater has cooled, clean it with a soft damp cloth, do not use detergents or abrasives. Periodically clean the air intake and outlet grilles during the period in which the heater is in use with a vacuum cleaner. Should the heater not be in use for a length of time, store it in a dry place. This appliance has been built to provide many years of trouble free service. In case of malfunction, do not try to repair the heater yourself: it may result in fire hazard or electric shock. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Only use the heater in an upright position. DCH2570E 4 - The heater must be positioned at least 50cm from walls, curtains, furniture or other objects. - If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. - Do not use this appliance in rooms which have a floor area smaller than 4m2 as this may lead to overheating. - The heater must never be placed immediately under a fixed mains socket. - Never obstruct the heaters intake and outlet grilles as this could cause dangerous overheating. - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. - A safety device intervenes and turns the appliance off and the pilot light will switch on in the event of overheating. To reactivate the heater, remove the plug from the mains, allow the appliance to cool (for about 10 minutes), remove the cause of the overheating and then plug the appliance back into the mains and turn it back on. - The use of an extension lead is not recommended, however if it is necessary then follow carefully the extension lead's instructions, and most importantly ensure that the extension lead is carefully rated in accordance with the radiator being used and NEVER overloaded. - In order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. - As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children. WARNING: In order to avoid overheating, never under any circumstances cover the appliances during operation, as this would lead to dangerous overheating. IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. [. . . ] If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. [. . . ]